[Jewelry making - Article 00603] - Re: [Orchid] File numbering system?

[Karen Seidel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Elaine The numbers on the files mean coarseness or fineness and
    the same as in metal the larger the number the finer (smaller)  the
    file. For example a 0 cut is fairly course, a 2 0r 3 is about medium
    and 4 is fairly fine. 

    Hope this helps. If I am unclear please feel free to email me. 

    Karen Bahr   "the Rocklady"  (rocklady AT nucleus.com) K.I.S. Creations 
    May your gems always sparkle.

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________