[Jewelry making - Article 00371] - [Orchid] Centrifugal casting machines

[musher]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Greetings to all, I just signed on to the list and I am looking for
    recommendations or suggestions about centrifugal casting equipment. 
    I did some jewelry making and a little casting some years ago. I
    would like to get back into it and want to purchase a small casting
    machine.  I will be casting only small jewely (rings, pendants,
    earings etc.).  I have a muffle furnace (5X5X8 id).  I have been
    looking at Kerr, Lucas, and Ney equipment (literature) and am at a
    loss as to what direction to take.  The Ney looks really safe and
    simple but pricey.  The Lucas and Kerr much better priced, seem to
    have good reputations.  Any suggestions, cautions, good or bad
    experiences?  

Thanks for your help.
-Brian 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________