[Jewelry making - Article 00354] - Re: [Orchid]] Flex shafts and pedals

[Poppy Vincent]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have a pro-craft flex shaft with a hand piece that uses a chuck
    key.  I bought a foredom quick release hand piece a couple of years
    ago and I've never been able to use it..  Apparently it can only
    work in a foredom flex shaft.  It seems to push the main spring up
    into the motor. Does anyone know what I could do to make it work or
    should I just break down and buy a new flex shaft and have two? 

God Bless you
~Poppy~
www.jewelrybypoppy.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________