[Jewelry making - Article 00106] - Re: [Orchid] Ceramic kiln for PMC?

[Susan Brandoli]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    A pottery kiln is fine but it works better if you have a electronic
    thermostat that measures temperatures rather than using cones for
    temperature accuracy. My Skutt kiln has a computer programmable
    temperature control which automatically moderates the temperature and
    lengths of firing to whatever I have programmed. Apparently the newer
    versions of PMC can be fired with just a torch for a few minutes but
    I have not tried these yet. Good luck. Susan Brandoli brandoli AT shaw.ca

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________