[Jewelry making - Article 00095] - Re: [Orchid] Ceramic kiln for PMC?

[Tom Manson]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello PMCers, I am having very good luck with a small enameling kiln
    that I bought from Amaco (in Indianapolis) for about $125. 
    According to PMC instructions, it can only be used with PMC3 (I can
    only get it up to about 1200F), but it works wonderfully with that. 
    It is really just a fancified "flower pot kiln" but it safely gets
    the job done with ease.  It holds more than I ever have to fire at
    one time and the firing cycle is only an hour (although I let it
    cool down at its own pace - which takes a several hours). Tom 
    http://www.geocities.com/miatagunner/currentworks.html

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________