[Jewelry making - Article 00753] - Re: [Orchid] Cad program update

[gregoire]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi everybody, excuse me for my clumsy english, but I'm not very used
    with it.... About CAD soft, I first started,a few years ago (2) with
    3D studio and lightwave (which is excellent-this is for Jon from
    Montreal), but, I discovered Rhino for modeling, and Cinema 4D for
    rendering, and now, I wouldn't change for anything in the whole world
    (as we say in France)........except for Matrix.  I just seen a
    'presentation' of it, not even an evaluation release, but, it sounds
    very, very good. Well, to be brief, my aim was to talk about
    TechGems, a soft wich interfaces in Rhino, you can, if you want, see
    more at: http://www.techjewel.com bye, and merry Christmas. Gregoire.

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________