[Jewelry making - Article 00036] - Re: [Orchid] Comfort Fit

[HooverStrongSB]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    The comfort fit designation applies to rings in which the insides are
    convex, and not flat. There is no standard measurement, as each
    manufacturer designs to his partuicular specs. We, at Hoover &
    Strong, just came out with "EZ" Fit wire which we sell in minimum 6
    inch lengths. Available in all metals, our measurements are 3, 4 and 
    5mm wide and all are 2mm thick. 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________