[Jewelry making - Article 00613] - Re: [Orchid] Comfort Fit?

[postmaster]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Dave, In my experience a true "comfort fit" is not simply a
    heavily beveled inside edge, but a low domed, half round profile on
    the inside of the band. Imagine a low domed, half round ring turned
    inside out so that the half domed surface is on the inside and you
    have a "comfort fit".  The inside is still completely round, it just
    minimizes the amount of metal to skin contact.  I hope this helps! 

Best regards,
John

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________