[Jewelry making - Article 00499] - Re: [Orchid] Technology & Success

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Suzanne: may not be what you are asking about but,I could not do
    without the 3m Radial Bristle Disc for polishing. They cut finish
    time and improve the quality. Low tech and not too expensive but very
    effective. Also couldn't live without the silicone based vulcanizing
    mold rubbers. Best thing to happen to mold rubber in the 27 years I
    have been making jewelry. Hope these are what you are looking for. 

Frank Goss

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________