[Jewelry making - Article 00312] - Re: [Orchid] How do I remove rust on rolling mill?

[joanna gollberg]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    the best method i have found is to regularly clean your rollers with
    WD40 and  a piece of steel wool.  this must be done REGULARLY,
    meaning almost every day at the end of work.  also make sure you
    don't leave little pieces of steel wool in the rollers, as that can
    mess up your metal next time.  so wipe them afterwards with a soft
    rag you keep just for this purpose, as the rag will retain some WD40
    in it as well... 
joanna gollberg 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________