[Jewelry making - Article 00211] - Re: [Orchid] Choosing between and rolling mill and an ultrasonic

[joanna gollberg]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    the mill came with 2 bolts.  at first i did not know why.  when one
    broke, i understood!  now i am very careful, as i will be without a
    rolling mill when this one breaks.  thanks for your email, though, as
    i woke up this morning thinking about making a solid bolt my own self
    to replace the "shearing bolt".  (i don't even know for sure if this
    is the proper name for this "bolt"!) but i will try to make one later
    on today and let you know what happens. thanks! joanna gollberg  

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________