[Jewelry making - Article 00101] - Re: [Orchid] Choosing between and rolling mill and an ultrasonic

[joanna gollberg]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    i bought a cheapie rolling mill from ebay for $250.  (made by PePe).
     it has one of the sheering bolts, and i cannot tell you how much i
    hate this thing. i use it only because i don't have any other rolling
    mill, but you can only roll with very little pressure.  i HIGHLY
    reccommend paying a litle more for a rolling mill with the bolt, even
    if you only have 50-70mm of flat rolling space.  this is a very
    important factor in choosing a rolling mill!  if only someone had
    told me about this!  

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________