[Jewelry making - Article 00083] - Re: [Orchid] Choosing between and rolling mill and an ultrasonic

[Tony]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    When you buy from Allcraft talk to Tevil there and let him know that
    you are a professionalism. Some of the mills are provided with a
    safety bolt in the handle that sheers if you try and pass a tough
    piece of material through it or something too wide for the gap
    between the rollers. This is there to prevent damage to the rollers
    but can be a real problem if you know what you are doing and want to
    push the limits of the toll. If he knows that you know what you're
    doing the bolt will be standard rather than a sheering bolt. 

Tony Konrath
Gold and Stone
http://www.goldandstone.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________