[Jewelry making - Article 00049] - Re: [Orchid] Choosing between and rolling mill and an ultrasonic

[\"Jeff\"]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Having already decided that I NEED a rolling mill, it now becomes a
    question of which one! Cavalin? Durston? PePe tools? ( Allcraft has
    these) 

    I am hoping for 100mm of flat, but with the combination mills the
    most flat surface I have been able to find is about 70mm. I looked
    into the mills where you can swap out the flat rollers for the
    combination rollers, but they weren't very impressive mechanically. 2
    Mills?  Given the price tag I am hoping to buy ONE and that it will
    last me a good long time! 

    Everyone I have talked to about this, to date, has had a serious
    prejudice for one manufacturer or another of them. So lets hear it!
    Which rolling mill? and WHY? 

Thanks
=jeff=

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________