[Jewelry making - Article 00015] - Re: [Orchid] Cutting Bullet Shape Stones

[coralnut]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    HMmmmm. Not sure what your requirement is.  Sounds like you want a
    simple preformer template...See Graves Lapidary, or look in the Lap
    Journal for other manufacturers who make preformers.  The diamond
    wheels are not normally made to cut a preform...the preformer is used
    to do it.  That doesn't mean such a wheel cannot be made but it might
    get pretty complicated and cost lots of dinaros.  Cheers from Don at
    The Charles Belle Studio in SOFL where simple elegance IS fine
    jewelry! dcdietz AT attbi.com 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________