[Jewelry making - Article 00698] - Re: [Orchid] Choosing between and rolling mill and an ultrasonic

[Dave Sebaste]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>     I have enough money for a Low end rolling mill or an ultrasonic
>     cleaners. 

    Tough call!  I use my ultrasonic more than I do my rolling mill. On
    the other hand, I have practical alternatives to the ultrasonic, but
    the mill is indispensable in the role it plays. When you need a
    rolling mill, you *need* a rolling mill! When you need an ultrasonic,
    you can usually get by with manual cleaning. 

Hope this helps,

Dave

Dave Sebaste
Sebaste Studio and
Carolina Artisans' Gallery
Charlotte, NC (USA)
dave AT sebaste.com
http://www.CarolinaArtisans.com 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________