[Jewelry making - Article 00001] - Re: [Orchid] Calculating metal gauge

[BKaline]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello Sherrie, You've no doubt already received several answers to
    your question about an "Idiot's Guide" for measuring things like
    sheet metal gauge thichness and drill sizes. I have always used a
    simple tool used as a "go/no go" guage often sold at machinist tool
    suppliers. These quick and simple guages require no skill to use and
    are not that expensive. I have one that measures both wire and sheet
    guage and another for drill bits. 

Bill

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________