[Jewelry making - Article 00500] - Re: [Orchid] Getting smooth surfaces on waxes and castings

[Gerald]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Kathy Let me interrupt this "string". I once saw wax carver use
    setters "Polishing Paper # 2/0, or even a finer # 4/0. The results
    were that you would believe he actually polished the wax design on
    the polishing machine. It was so-o smooth, it was hard to believe it
    was only a only a wax. I would hasten that you should give it a "try"
    on something less delicate or important, just to get the hang of it!
    "Gerry, the Cyber-Setter !" "www.gemzdiamondsetting.com"

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________