[Jewelry making - Article 00669] - Re: [Orchid] Holding small objects

[Don Rogers]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I also use this material to line the base of my polish lathe.  I
    roll it up the back so the vacuum system is pulling through it.  If
    I happen to have a piece snagged out of my hand while polishing, it
    has a somewhat soft landing vs slamming into the metal base.  It
    doesn't save them all, but most of them come out OK.  I don't need
    this very often, but every now and then, it pays for its self. 

Don at Campbell Gemstones.

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________