[Jewelry making - Article 00163] - [Orchid] Odd Ball shape part to cast

[Clinton Driggars]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have a part I would like to cast if  possible. I looks that
    originally it was pressed and formed. It is an interior windshield
    post trim. There is a left and right. The part is in a C shape but
    is wider at one end than the other, and has curves also. I have
    tried every way I can think of to cast in sand, but I just can not
    come up with a way to remove the part. I will post some pics, 6 in
    all, so I will do in 2 emails. You can also look at an older car at
    the trim and get a better idea on the shape. Anyone's help, I would
    be thankful Clint D 

Visit my Ebay Store
http://www.ebaystores.com/cjsalesandequipment

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________