[Jewelry making - Article 00080] - Re: [Orchid] Gold French Wire

[Tony]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I've tried to produce French wire in both silver and 18ct but the
    results were very unsatisfactory. They are just too soft and won't
    do the job. It's perfectly acceptable to use the standard plated
    wires for stringing. Don't worry about the issue of quality marks.
    The amount you is so small that It won't make a difference in the
    overall percentage 

Tony Konrath 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________