[Jewelry making - Article 00240] - [Orchid] Alternative for engraving block

[marco mandragon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi All I just bougth a small book of engraving in which I saw a bench
    vice as an alternative to holdlarge piecesor guns for engraving .the
    book doesn't explain in big detail how to assemble this bench vice I
    guess it has to go on top of that kind of bearing discs in which the
    rotating showcases or displays for jewelry spins . I wonder if
    somebody is using this method or something similar to
    holdlargeobjects to be engraved or perhaps as an alternative for the
    expensive engraving blocks .The question is how to make a benchvice
    to spin as an engraving block.Of course it is not a regular heavy
    bench vice but something like a flat vice for carpenters  Any advice?
     
Marco

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________