[Jewelry making - Article 00206] - Re: [Orchid] Wax model making

[Bill Wismar]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Sometimes you have to look at the job and decide which way is the
    best way to make a piece.  Personally I think you would be better off
    actually sawing (piercing) the piece out of sheet.  You would end up
    with a cleaner piece and it would be much faster to make.  Plus you
    would not have to worry about it not casting correctly.  You do need
    to figure in the cost of the metal that is waste if your using gold. 

Just my penny's worth
Bill Wismar
www.wismargallery.com 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________