[Jewelry making - Article 00197] - Re: [Orchid] Wax model making

[Patania's]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear Ellen, is this going to be cast in metal? I would not bother
    with wax but draw my lay out on paper - to scale- and use pliers to
    bend wire in the shapes you require. 20 to 26 gauge is easy to move
    if annealed or you can use fine gold or silver which is available
    annealed from the refiner. Sam Patania, Tucson 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________