[Jewelry making - Article 00157] - [Orchid] Wax model making

[LEOB2000]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello, Thank you the opportunity to ask a question. As a relatively
    newcomer to wax model making I have been given a project that I must
    create a tiny curvy line about 26 gauge. Also I must create cursive
    writing about  20-22 gauge (like you may see on a birthday cake). I
    am stumped on how to do this. Commerical wax wire is to thick and
    difficult. It is as if I need some type of small tool to push hot
    wax out while writing at the same time..None of my tool supply
    catalogues give me any clues..Help! Thank you for your attention and
    thoughts. Sincerely, Ellen Borlenghi

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________