[Jewelry making - Article 00113] - [Orchid] Finishing no enamelled surfaces

[mfs vicenza]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear Orchidians, I am a jeweller from Vicenza in Northern Italy.I am
    trying to obtain jewellery with gemstones and enamels. I prepare the
    metalwork (yellow gold alloy 18 Kt) annealing and pickling
    repeatedly until no discoloration is produced by the annealing
    (depletion gilding). When I use green and blu enamels (those that I
    have tried till now ) I get good colors. I obtain good results also
    in enamel finishing. The question is that I am not able to finish
    the no enamelled metallous surface; it remains always crinkled even
    if subsequently I use deburring blocks , polishing paste (rouge) and
    finally "diamantine" pasta.This happens also on silver (sterling)
    surface.Do You have any suggestion? 

    Thank You very much for Your help.! 

Mariano 
mfs.vicenza AT libero.it

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________