[Jewelry making - Article 00108] - Re: [Orchid] Backing plates for rolling mill

[Noel Yovovich]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>      to use my club's rolling mill to roll print titanium, I understand
>     I would use a couple of brass plates to sandwich things with. 

    If you mean that you want to print *onto* titanium--I wish you luck.
    If you manage to do it, let me know! Niobium prints well, but ti is
    really too hard. 

    If you want to use cut-out ti to print on another metal--that wirks
    pretty well. Sandwich with any non-ferous metti can damage your
    rollers.                             

Noel 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________