[Jewelry making - Article 01195] - [Orchid] [Favorite tips] Rolling Mill

[Brad Simon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Reducing the width of a rectangular wire can be difficult, as the
    wire tends to turn while rolling.  To alleviate this problem hold
    the wire in a pair of parallel pliers leaving about a half inch
    protruding from the jaws.  Feed this end into the rollers until the
    jaws of the pliers make contact with the rollers.  As you continue
    to roll, allow the wire to pull from the pliers.  The force of the
    plier's jaws will keep the wire upright. Brad Simon CMBJ 
    www.BWSimon.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________