[Jewelry making - Article 01158] - Re: [Orchid] Knob blanks?

[coralnut]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dave, Last year a gentleman came to our G&M Society asking us to
    drill over 30 small stones of various types shapes and sizes for use
    as knobs on kitchen cabinets.  We drilled them with 3/8 inch core
    drills making the holes about 1/4 inch deep.  He was then going to
    epoxy short lengths of threaded rod into them, place a spacer on
    that, insert through holes in the cabinets and use a nut to hold them
    in place. 

    Haven't heard back but assume all went well. 

    Cheers from Don at The Charles Belle Studio where simple elegance IS
    fine jewelry! dcdietz AT attbi.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________