[Jewelry making - Article 00969] - Re: [Orchid] Burnout Furnace Controller from a PC

[DaveRhyne]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Ben, I have located a temperature controller that I believe has 8
    programmable temperature ramp/hold cycles that I am planning on
    using to control my burnout oven. I have priced several similar
    controllers sold by various kiln suppliers and the cost was way over
    my budget. This unit sells for approx. $125 plus the cost of a
    thermocouple for the temperature range you would require. This might
    be as economical as trying to adapt your PC. The web address is
    WWW.pfinst.com 

    I spoke with Bob (last name unknown) He was very happy to discuss my
    particular needs.  He will need to know the rating of your oven
    (voltage and current). 

Good luck 
dave
daverhyne AT aol.com 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________