[Jewelry making - Article 00964] - Re: [Orchid] Burnout Furnace Controller from a PC

[Ken Kotoski]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


Hi Ben,

    Yes there are cards available and software.  They are not cheap and
    run about as much as one of the already made oven controllers on the
    market. In addition to the card and software a solid state relay
    will be needed and the thermocouple on the oven will work unless you
    want a new one in which case any type 'K' thermocouple will work. 

    Another option is a DIN panel mount process controller which can be
    mounted in you oven and programmed for many stages and ramps. The
    Din controllers are much less expensive than the first two options. 

    If you want further info on any of these let me know. 

    You can contact me at the email address above or calling toll free
    1-877-262-2185. Ask for Ken at MPG Repair. We sell and repair the
    tools jewelers use. 


Ken Kotoski
MPG Repair
www.mpgrepair.com
1-877-262-2185  

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________