[Jewelry making - Article 00147] - Re: [Orchid] Searching for C- shaped cross section wire

[Mastermodels]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    If you have a drawplate you can make it by soldering the tips of two
    wires together, filing a point, putting it through a round hole
    drawplate and drawing it down.  If you meant D shape.  However C
    shape I am not familiar with. Ed Dawson www.truequalityendures.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________