[Jewelry making - Article 00106] - Re: [Orchid] Polishing holes

[Nancy Bernardine-Widmer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I've used tooth picks, the end of various sized chop sticks and cue
    tip ends depending on the diameter of the hole.  The cotton on the
    cue tip holds the buffing compound very well but you must peel off
    some of the cotton and its a throw away after almost every use. 

-- 

Nancy
Nancy Bernardine-Widmer
Bernardine Fine Art Jewelry
http://www.bernardine.com
mailto:nancy AT bernardine.com 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________