[Jewelry making - Article 00022] - Re: [Orchid] Jump Ringer Problems

[Ray Grossman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    As I stated in a previous message, all Jump Ringer coil holders are
    now made with four sides. They will cut coils well in excess of 1
    inch in diameter. If you purchased it recently, you  probably
    received old inventory from your dealer. I'd suggest you speak with
    the dealer. Although more expensive, the new coil holder is a vast
    improvement over the older one. Ray Grossman Ray Grossman Inc. 
    Manufacturers of Jump Ringer

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________