[Jewelry making - Article 00898] - [Orchid] Polishinh holes

[Mark Zirinsky PEMED.com]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I am starting a project, where I will be drilling holes in a faceted
    stone, and need to polish the inside surface. 

    Drilling is easy enough - anyone have any ideas, on how to polish
    the inside? I have the usual sequences of diamond paste available
    (220,600,1200,300,14,000, 50,000) 

    I just do not know what to use for a tool, Hole diameters are 0.75
    mm to 1.5 mm . 

Mark Zirinsky, Denver

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________