[Jewelry making - Article 00119] - Re: [Orchid] Glass Engraving

[Epaul Fischer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    For a dental style tool (air turbine) I heartily recommend the
    Turbocarver ( http://www.turbocarver.com ) It is currently $207 for
    the basic system and $307 including a water mist system that has
    made my life as a gem carver  better and less messy. Not to mention
    vastly extending the life of my dental burrs. It uses HIGH RPM and
    low torque. You can order their instructional video for $20, which
    they will apply towards purchase. That's what I did 3 years ago. In
    the video they show someone holding an incandescent lite bulb in
    their hand, carving their signature on it, then drilling through it.
    Pretty nifty. Good people with great customer service. Usual
    disclaimers - not affiliated, just a happy customer. -- Epaul Fischer
    Gryphon Song Creations < http://GryphonSong.com > Phoenix, AZ USA 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________