[Jewelry making - Article 00050] - Re: [Orchid] Glass Engraving

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    From your posting it seems that you are looking for a Turbine or a
    Micro motor. A Turbine tool works on air and a Micro motor runs on
    an electrical motor. These run a 25,000 to 35,000 rpm. Price for a
    good professional quality will run from about $250 & up usually made
    in Japan, Korea or Taiwan. The Nail industry has some Micromotors
    that are made in China that could be cheaper. You should look for one
    that will accept 3/32" shaft so that you can use all the diamond
    burs that are readily available in the dental & jewelry field. 

Regards  Kenneth Singh 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________