[Jewelry making - Article 00019] - Re: [Orchid] Silver and pearls

[Suzanne Boschen]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear Steve, I am not sure about the tarnish preventors, but I do know
    that eventually the silver WILL tarnish and then what ya do!!!!
    Well, I had the same problem and the only two things I found that
    would clean silver and not hurt pearls, were Haggerty's silver foam
    (to do by hand) and the Speed Brite unit previously discussed on
    this forum (check archives). Regarding the preventors, why don't you
    take a loose pearl and give it a try? 

Hope this helps,
Suzanne 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________