[Jewelry making - Article 00077] - Re: [Orchid] hammer handpiecs

[J Morley]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    All, I have been using a fordom hammer handpiece for seven years at my
    bench and it has worked great.I work full time and use it almost every
    day It looks like a truck ran over it.I have had to take it apart a
    couple of times and fix the spring just a minor tightening.It also has
    the flex connection which I would recommend.I have used it for hammer
    setting channel set stones,bezel set stones,prong set occaisionally 
    and burnishing pits in castings and solder joints also riveting and
    hinge pins and texturing.I grind the tip to fit the job making sure
    not to over heat it.Regards J Morley Coyote Ridge Studio Where tonight
    the coyotes ARE howlin and our dogs are talkin back!  

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________