[Jewelry making - Article 00071] - Re: [Orchid] Shear Stupidity

[James Bergen]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Rene', Try using Sheet Metal shears ("Tin Snips"). Also wire cutters
    will work, just don't use dikes that are too small. At least 6"-8"
    dikes should cut with almost no effort. Depending on your strength the
    larger, the easier to cut. Please note that I said Dikes not Linemans
    Pliers! Linemans pliers are great, but not for cutting wide mesh! 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________