[Jewelry making - Article 00932] - Re: [Orchid] [again] Purchase new flex shaft

[MBISCAY]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Felicity - My vote is firmly behind the Foredom - I've owned two
    for years and I've run them hard - I've replaced the shafts and
    springs several times, and other than lubricating them every 4-6
    months, I've not needed to do much else with them. Parts are
    readily available - at least on this side of the pond - and I
    don't even need an owner's manual to figure out what needs
    fixing - it's a fairly straightforward machine. It sounds to me
    like $200 is worth the trouble of importing - how much is an
    Australian dollar in real money, anyway? 

    Mike (in chilly, parochial Toledo, Ohio) 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________