[Jewelry making - Article 00104] - Re: [Orchid] Building a kiln

[David L. Huffman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Perhaps you could build a gas fired kiln with two side-by-side
    chambers, then use two burners, also side by side hooked up to
    seperate control valves.  I wouldn't think you'd want  to use two
    pyrometers/thermocouples though, because of the expense.  Perhaps the
    thermocouple (if you used one) could be made to slide out of one and
    into the other.  Take a look at www.abana.org, the blacksmithing site
    for some info on building gas forges, perhaps this would help. 
    Mayber there are some ceramicists out there who might know of sites
    with kiln plans.  Good luck. 
 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________