[Jewelry making - Article 00026] - [Orchid] Building a kiln

[Richard Whitehouse]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I would like to build a gas kiln for burnout and enameling. I suppose
    the best way would be to use steel sheet and weld it. Then use
    firebrick to line it. I would be very grateful for any ideas on how
    to tackle this project. If anyone has any plans that would be even
    better! 

Richard
The first step is a journey of a thousand miles 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________